JULY HOT PICK SPECIALS!

Over 100 Lower than low prices! Check'em out by clicking here!

MUSTANG GAS TANKS... MID May Clearance!

Tank 1 - 3.3 gallon single cap, $87

-16.25" long and 11.5" Wide (TANK)
-20" long from tab to tab.
-Tunnel is 2-1/2" wide and is 2-3/4" at the deepest point.
-Two 1/4" NPT gas tap holes at the rear. (British Threads for English Petcocks)
-One 3/8" NPT gas tap hole on the right hand side in front (HD American Thread)

-Tabs are not drilled.

Tank 2 - 3.3 gallon dual cap, $85

-16.25" long and 11.5" Wide (TANK)
-20" long from tab to tab.
-Tunnel is 2-1/2" wide and is 2-3/4" at the deepest point.
-Two 1/4" NPT gas tap holes at the rear. (British Threads for English Petcocks)
-One 3/8" NPT gas tap hole on the right hand side in front (HD American Thread)

-Tabs are not drilled.

Tank 4 - 2.8 gallon dual cap, $77

-16.25" long and 10.5" Wide (TANK)
-20" long from tab to tab.
-Tunnel is 2-1/2" wide and is 2-3/4" at the deepest point.
-Two 1/4" NPT gas tap holes at the rear. (British Threads for English Petcocks)
-One 3/8" NPT gas tap hole on the right hand side in front (HD American Thread)

-Tabs are not drilled.

Tank 6 - 2.2 gallon dual cap, $75

-16.25" long and 9.75" Wide (TANK)
-18" long from tab to tab.
-Tunnel is 2-1/2" wide and is 2-3/4" at the deepest point.
-Two 1/4" NPT gas tap holes at the rear. (British Threads for English Petcocks)
-One 3/8" NPT gas tap hole on the right hand side in front (HD American Thread)

-Tabs are not drilled.

Gas cap for these tanks, $4.00ea

While supplies last. No rain-checks. Shipping not included.

Transition Photo-chromatic Goggles!

No more changing out lenses! The FREEDOM (top) and The NOMAD w/ Photo-chromatic Lens, by Airfoil: The lenses are dark outdoors in the daylight and lighten automatically to almost clear when worn indoors or at night.

Comfort and function are key with these special padded goggles. As an added feature the padded frames float, making them excellent for use on watercraft.

• Folds neatly into its own pouch
• Lightweight
• 100% UV protection
• 100% Shatterproof polycarbonate lens

Our Price and Your Choice $59.00USD

Going Batteryless with electronic ignintion

Single Phase 210W, 16 AMP kit with rotor, Single Phase Rectifier/Regulator/Capacitor box with 5000ohm Resistant plug caps - This is the easiest and most cost effective way of running your British Iron with electronic ignitions and having the option to NOT run a battery. 3 Phase alternators REQUIRE a battery to work properly. (Hi Output 3 phase kits are also available) The kit easily outperforms standard equipment especially at the lower rev ranges. Ideal for using Halogen bulbs, electronic ignition systems and heated grips. Due to the sensitive nature of single boxes it is VERY important to fit spark plug caps of the 5000ohm resisted type. Failure to do so will cause overloading. Resistant Spark plug caps are *included* in our kits.
Retail Price - $298 without resistant caps ($4-6ea)
Our Price - $262USD, w/5000ohm caps included (single or 3 phase)

New Slim-Line Triumph Bonneville Gas Tank

Modeled after the 1970 Bonneville (83-1798). Made of 1 gauge thicker steel than the original tanks. Uses original mounting hardware, petcocks, gas caps, badges, and tank strip too!
SRP $493.00 / Our Price: $349USD - Worldwide shipping

Plunger Section 63-70 Triumph 650 / T150

These bolt-on sections are very similar to those used by BSA and Indian in the good old days, and to the custom "Santee Softail" or "Amen Saviour" of the '70s. Axle carriers and springs are chrome plated and require the use of the 37-2089 axle adjusters used on virtually all pre-oil frame Triumph rear wheels. These plungers are designed to be used with the pre-oil frame Triumph rear wheel setup. $490 USD / Worldwide Shipping

Custom Riser Sets

Made to order and turnaround time is 10 business days.
* Options include:

• Aluminum or Stainless Steel
• 7/8" or 1"
  
• Round Edged(L) and Straight Edged (R)
• Rise 1-6"
• Cost ranges from $49 - $109USD
  

Triumph / BSA Weld-on Hardtail - Disc Brakes

Fits Unit (OIF) Oil in Frame Twins w/ disc brakes.
Heavy duty axle ends and quality welds. Quantities limited.
$238 USD / Worldwide shipping

Triumph / BSA Weld-on Hardtail - Drum Brakes

Fits Unit (OIF) Oil in Frame Twins w/ drum brakes.
Heavy duty axle ends and quality welds. Quantities limited.
$238 USD / Worldwide shipping

4 Wassel Style Petrol Peanut GasTanks

#1 Vintage, Authentic, unmolested, dent free. Has old style petcocks, but seems to have never been used by way of not having and gas smell. Inside has oxidized surface rust only. Seem to be original paint just scuffed up from storage. Total runner as is or strip and paint. Vintage English Chrome cap comes with it, in 8 out of 10 condition, just not shown. Stamped Made in England. $SOLD

#2 Vintage, Unmolested, dent free. Never been used. Inside has oxidized surface rust only. Seem to be original paint just minor scuffs from storage. Small flaw in paint top left nose end...as maybe a bit of battery acid had dropped on the pain. I'd sand it down and hit it with some black gloss spray and roll. New English Chrome cap comes with it, just not shown. Total runner as is or strip and paint. Stamped Made in Japan $SOLD

#3 Authentic, used and stripped. Definitely has been used with minor abuse. Some small dings here and there circled with chalk in pictures. Someone seems to have used a stripping pad to remove the paint. Appears the tank used to be yellow. Tabs are securely welded. Inside has oxidized surface rust only. New English Chrome cap comes with it, just not shown. Stamped Made in England. $SOLD

#4 Authentic, used and painted flat black. Rare "Banana" Style Couple very small dent in top right side but can only see at certain angles. Looks like some minor repairs and bondo on a dent in front of the cap on the nose side. Good job repair, and barely noticeable. Vinyl decal "Triumph" on one side. One petcock has been plugged but could easily be tapped and driven out. Underside looks to have several well done repairs on the seams. Tank has been sealed with RedKote. Total runner. $SOLD

$109 PWK Carburetors, Quality Amal 600 / 900 series replacement!

These are PWK carbs are offered in two sizes, 26mm and 30mm, as a direct replacement for stock Amal carburetors.

The PWK 26mm - 600 series concentric carburetor replacement. The spacing for the flange is 2" on center. This can be jetted to your specifications or it is preset for 500 British twins, T150 / T160.

The PWK 30mm - 930 or all 900 series concentric carburetors replacement on Triumph, Norton, BSA, and other British motorcycles. These will fit a standard flange mount manifold with a hole spacing of 2" on center. The flange can be removed for spigot type mounting such as Later OIF Triumph. Spigot OD is 34mm, carb total depth is 82mm, and the height is 5" minus cable adjuster. The air intake is 48mm OD. This will fit where any Amal 930 Concentric or Monoblock is installed.

Both carbs will accept your stock Norton, Triumph, or BSA cables, and stock air filters that use the threaded removable insert, or later Air box applications.

These PWK carburetors have gone through strenuous and extensive testing and development, to bring you an alternative to the poor design of the Amal and the costly price of the Mikuni. You can convert this carb to a left or right hand application, by moving the idle screw to the other side for easy access, the fuel enricher plunger and air mixture screw remains on the left side, similar to MK3 Amals. Comes complete with every thing you see in the left picture, drain lines, o-ring, and one carb. So just bolt these on and enjoy years of trouble free motoring.
YOUR CHOICE, Only $109/USD each!
__________________________
Velocity Stacks: $26 short, $28 medium,$28 tall

Pancake Filter (Straight or Offset): $26ea Cone: $14ea

Email: bret@skinandbonecustoms.com to order yours!

Modern Motorcycle Mechanics (7th Edition) 1974 By J.B. Nicholson.

**Limited new thirty-four year old inventory of this incredible motorcyclist’s bible just unearthed!

"A complete encyclopedia of motorcycles." 760 pages, 360 illustrations - full of valuable, interesting, and easy to understand information on what you want to know about motorcycles. 360 illustrations - these clearly show what you need to know for adjusting, dismantling, and assembling work on most servicing operations. Servicing - There are fifteen individual servicing chapters, covering British, American and Japanese makes. Special Chapters - cover motorcycle design, trouble tracing, machine shop methods, and speed tuning. The masterpiece of motorcycle mechanics publications. A world-class reference on motorcycle design, operating, maintenance and overhaul. This book will save you many times its cover cost in repair savings. Buy yours now, don't miss out! $75 shipped in the C.USA, WW $90

UK Steel Ribbed Rear Fenders / Mudguards!

Get yours while supply lasts! Contact bret@skinandbonecustoms.com
5 inch Raw Steel
$99/ea
Curvature: 51", Tip to tip: 30-1/2", Width ID: 4-1/4"
Height: 17", Depth: 1-1/2"
__________________

6 inch
$109/ea Raw Steel
Curvature: 51-1/2", Tip to tip: 29", Width ID: 5-1/2"
Height: 17-1/2", Depth: 2-1/4"

QD Rear Wheel Assembly

Only 2 left in stock!
NOS UK Made!
VERY Limited Quantities! No Rain Checks! No Back Orders!
Triumph/BSA # 37-2290 WM3 x 18, QD Rear Wheel Assembly

New Jones Chrome rim, New Bearings, New Spokes - Laced and Trued and ready to go!
Retail $498.00 Our Price $448
Contact bret@skinandbonecustoms.com to get yours now!

Holy Bananas!

Holy Banana Z Handle Bars
Bringing that way cool classic back in better quality and thicker gauge!

• Heavy duty 7/8" tubing in raw or stainless
  
• 6" Rise, 5" Pull Back
• 9" Center Mounting bar
  
• Exclusive part designed and distributed by SNBC.

Raw Steel - $125 , Stainless - $175
Made to Order, 2.5 week turnaround
Contact us to order yours today!